Electric Forced Air Heaters - 5000 W, 17100 BTU 20" Horizontal Discharge Unit Heater - TPI G1GUH05003
This is perfect choice for convenient and safe heat for your place. Buy Electric Forced Air Heaters made by TPI. Model G1GUH05003 is 5000 W, 20" Horizontal Discharge Unit Heater that yields an 17100 BTU output. The model comes with circular copper clad steel element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade. It has 18 ga. steel cabinet with powder coated finish and control compartment with a hinged and latched access door which simplify wiring installation and maintenance. The Fan assembly is enclosed by a heavy gauge, close spaced, chrome plated wire guard.
| Horizontal Discharge Unit Heater - 17100 BTU - TPI G1GUH05003 Specifications |
|---|
| BTU | 17100 |
|---|
| KW | 5 KW |
|---|
| TEMP RISE | 40 F |
|---|
| CFM | 400 |
|---|
| Amps. | 18.1 |
|---|
| Phase | 1 PH |
|---|
| Air throw | 26' |
|---|
| Voltage | 277V |
|---|
| Control Volts | 277 |
|---|
| Recommended Mounting Height Hortz | 9' |
|---|
| Product Dimension | 20"L x 11"W x 13"H |
|---|
| Weight | 36 Lbs. |
|---|
| UPC | 686334644730 |
|---|
Horizontal Discharge Unit Heater - 17100 BTU - TPI G1GUH05003 Features:
CONSTRUCTION: - 18 ga. steel cabinet with powder coated finish and control compartment with a hinged and latched access door, simplifying wiring installation & maintenance
HEATING ELEMENT: - Circular copper clad steel element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade
OVERHEAT PROTECTION: - This unit equipped with automatic reset type limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR: - Totally enclosed, single phase, permanently lubricated, thermally protected motors with this 5 kw unit.
- Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard.
LOUVER ASSEMBLY: - Louvers are individually adjustable for directional control of air flow and the louver assembly can be repositioned in the field from down air flow to right or left directional air flow.
INSTALLATION:- UH Series may be mounted at a maximum of 45 degrees off of horizontal
- On all models up to 15 KW, 1/4" threaded rod may be used for mounting; on all models 20 KW and above 5/16" threaded rod may be used
- Optional wall / ceiling mounting brackets available for all units
- Suitable for applications up to 13,000 feet
FACTORY INSTALLED OPTIONS: - 24 volt transformer on 3 KW to 15KW units to convert from line voltage to low voltage remote thermostat operation (non CA1 models only)
- Summer fan switch to operate the fan only.
- Fan Delay Switch to purge all residual heat from the unit after the heating element has cycled off
- Powder coated Epoxy finish is available
- Disconnect switch
- ETL listed