Electric Forced Air Heaters - 7.5KW 5100 Series Horizontal/Vertical Discharge Fan Forced Suspended Unit Heater - TPI F2F5107CA1L - 25.6 BTU/Hr
7.5 KW 5100 Series Horizontal/Vertical Discharge Fan Forced Suspended Unit Heater is one of the best quality product by TPI , that assures long term investment and relief in winters. Model F2F5107CA1L has 18 ga. steel cabinet with powder coated finish. This unit comes with In-built or wall mounted temperature control thermostats - low or line voltage. Buy this multi featured unit NOW!
| Fan Forced Suspended Unit Heater TPI F2F5107CA1L Specifications |
|---|
| UPC | 686334645201 |
|---|
| Power | 7.5 KW |
|---|
| BTU / Hr | 25.6 |
|---|
| VOLTAGE | 208 V |
|---|
| PHASE | 1 / 3 |
|---|
| AMPS | 36.1/20.8 |
|---|
| Control Voltage | 24 |
|---|
| Temperature Rise | 34 F |
|---|
| Air Throw | 22' |
|---|
| CFM | 700 |
|---|
| Recommended Mounting Height (Horizontal) | 10' |
|---|
| Recommended Mounting Height (Vertical) | 12' |
|---|
| Dimensions | 24-1/3"H x 21-1/2"W x 6-1/2"D |
|---|
| Weight | 54 Lbs. |
|---|
Fan Forced Suspended Unit Heater TPI F2F5107CA1L Features:
CONSTRUCTION:
- 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance
HEATING ELEMENT:
- Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow
OVERHEAT PROTECTION:
- 3.3 - 50 KW units come equipped with automatic reset type limit and 60 - 100 KW units come equipped with manual reset type limit to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR:
- Totally enclosed, 1-speed, 1-phase, permanently lubricated, thermally protected motors with unit bearings on 3 KW - 20 KW models Totally enclosed, 2-speed, 1-phase, permanently lubricated, thermally protected motors with sleeve bearings on 25 KW - 50 KW models; 60 -100 KW have 1 speed motors, ball bearing, thermally protected.
- Fan over-ride purges unit of residual heat at shutdown
LOUVER ASSEMBLY:
- Louvers are individually adjustable for directional control of air flow up to 15 degree from straight horizontal
- Optional diffusers available for down flow (vertical discharge) applications
TEMPERATURE CONTROLS:
- Optional low voltage and line voltage thermostats available with an adjustable temperature range of 50 degree -90 degree F
- Units with model numbers ending in CA1 are factory wired for low voltage controls
- 25 KW through 50 KW units are designed for two stage heating operation, 60 - 70KW units designed for up to three stage and 80 - 100 KW units up to four stage
INSTALLATION:
- Unit Heaters can be mounted for horizontal or vertical discharge
- 5100 series suggested for applications up to 6000 feet; for applications up to or above 6000 feet see UH series.
FIELD INSTALLED OPTIONS:
- In-Built or wall mounted temperature control thermostats - low or line voltage
- Summer fan switch to operate the fan only.
- Power disconnect switch
- 60-100KW units can be multiple stage when used with optional SC5100 and C1025 stat
- Heat stratification thermostat
