Down Flow Unit HeatersTPI 5 KW, 240V Downflow Unit Heater - H3H2605CA15 KW Downflow Unit Heater comes with 17065 BTU and 16 ga. steel cabinet with epoxy powder coated finish. TPI H3H2605CA1 features control compartment with a hinged and latched access door, OSHA approved, corrosion resistant element with steel sheath and steel spiral fins, manual reset limit controls to de-energize the heater and fan purge that allows fan to operate after elements are de-energized to purge residual heat. | Downflow Unit Heater - TPI H3H2605CA1 Specifications |
|---|
| Wattage | 5 KW |
|---|
| BTU | 17065 |
|---|
| Voltage | 240 |
|---|
| Phase | 3 |
|---|
| Ampere | 12 |
|---|
| Control Voltage | 24 |
|---|
| Temperature Rise | 34 F |
|---|
| CFM | 490 |
|---|
| Dimensions | 15"H x 20-1/2"W x 20-1/2"D |
|---|
| Weight | 75 Lbs. |
|---|
| UPC | 686334715799 |
|---|
Downflow Unit Heater - TPI H3H2605CA1 Features: CONSTRUCTION: - 16 ga. steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door
- OSHA guards standard with all models
HEATING ELEMENT: - Corrosion resistant element with steel sheath and steel spiral fins
OVERHEAT PROTECTION: - All units come equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR: - Totally enclosed, 1 speed, 1 phase permanently lubricated, thermally protected motors with unit bearings
- Axial flow fan blade - 1570 RPM max.
- All Models equipped with Fan Purge which allows Fan to operate after elements are de-energized to purge residual heat
TEMPERATURE CONTROLS: - In-Built 24 volt transformer for low voltage remote thermostat application
DISCONNECT SWITCH: - This unit is equipped with In-Built Disconnect
INSTALLATION: - Unit can be mounted using optional mounting bracket or field constructed angle iron bracket
- Not recommended for mounting with threaded rod or chain
|
